RE: No Outputs (Mistubishi Q-Series/GX Works2). It's worth noting that this software was maybe not from GX Works2 originally, are there usually 'change over' issues? If yes, how could we get around it?Īny help appreciated. I then forced several outputs on in the plc, no output lights illuminated on the output cards.Īny suggestions to why we're not getting any outputs? I spent a good 4 hours going through the PLC parameters tabs, ensuring cards to rack set ups are correct etc etc At this point, I checked the +24v on the cards, 24 was present. Going back to the panel, I followed solenoid cable back to output and noticed no outputs were illuminated. There is a solendoid switch on the manifold which comes directly from an output of the PLC.

When digging a bit deeper, there was no compressed air to the valves.

This was working as expected, but not all cylinders were going to home. length0 // not designed to work with adapters. According to equation 2, work out the relative curve on 3D grid for the point (a,b,r). Looking at the software, the 'reset' button held for 5 sec would switch on a 'go home' marker. The Boolean data type: A Boolean variable may have two possible values: True. The size of parameter space depends on the maximum and minimum. You could see inputs switching as buttons were pressed.

I re-loaded the software and got it to monitor. The program given to us was on GX Works 2 which we have no experience of). The PLC is question was a Mitsi Q-series. Our training engineers have the real experience on-site service as well as joining the training aboard which conducted by MITSUBISHI. To make our training more effective, we provide a real training kit for our trainees to study in pair. Each of classes can support up to 22 trainees. I'm no PLC expert, still learning, have experience on GX developer and Mitsi PLC's. Training courses are ranged from beginning to advance. We've managed to source the software and I was supposed to re-load yesterday. They have a fairly old machine that PLC's battery died and they lost the software. Our firm has a section of our machines subbed out to another company.

Gx works 2 parameter